News RSS

This is important advice when considering installing a hot tub into decking. When you build decking around your spa it is important that you create an access point to inspect/repair internal hot tub components (i.e. plumbing, control unit, heater, pump etc.). We suggest you incorporate a hatch or removable panel in order for a service engineer to access the hot tub to carry out repairs. …its best to locate your spa near your house for convenience …and finally make sure you leave up to a metre of space around your hot tub to allow for fitting a cover lifter as well as service...

Read more

The cloudiness is the result of undissolved particles. Regular water treatment is required to keep the water in the spa clean. To keep your spa water clear we recommend you use Spa Clear – this coagulates or “sticks” small particles together which would normally filtrate through the filter media. TIP: Using this product after cleaning your filters will immediately improve their effectiveness and help to restore their particle-trapping properties. Helps to restore sparkle, without a shock dose. It is advisable to change your water regularly (every 2-3 months) depending on usage.

Read more

Canadian Spa Co. Manufacturing extends the following warranties to the original purchasers of its portable spas. Vinyl warranty (1 year) Plumbing warranty (1 year) Equipment warranty (1 year) Extent of Warranty: This limited Warranty applies to portable spas manufactured after May 1, 2014 and sold by authorised Canadian Spa Co. dealers to residential retail customers. This Limited Warranty is given only to the first retail purchaser and terminates upon transfer of ownership. No warranty is provided on filters or any dealer installed accessories. Cost of installation, removal and/or shipping of the spa is not covered by this Limited Warranty. In the event Canadian...

Read more

The new filter/skimmer basket from Canadian Spa offers improved 100 sq ft filtration (2 x 50 sq ft Silver Ion ‘Microban’ filters) together with a Pre-filter mesh to capture impurities. This guide instructs how to change filters/Pre-filter. Changing the filter cartridges and pre-filter:           Step 1. Remove the two screw cap covers. Undo the two screws to release filter lid            Step 2. Open the filter lid to access the filter chamber.           Step 3. Unscrew the two filters and replace with the new filters and re-screw into position    ...

Read more

Please check whether connectors are tightened or seal ring and O-ring are damaged. Replace the seals ring or O-ring if necessary.

Read more