Proper filtration is crucial to maintain the correct chemical balance of your spa’s water and can further increase the longevity of your spa equipment.
The following spa filter cycle guide is for the following Canadian Spa models: Alberta, Niagara, Thunder Bay, Vancouver, Victoria.
Pre-set Filter Cycles
The first filter cycle begins 6 minutes after the spa is energised. The second filter cycle begins 12 hours later. Filter duration is programmable for 2, 4, 6, 8 hours or for continuous filtration (indicated by “FILC”).The default filter time is 2 hours. To program, press “Warm”or “Cool”, then “Jets 1.” Press “Warm” or “Cool”to adjust. Press “Jets 1″ to exit programming. Pump 2 purges for 5 minutes and the blower purges for 30 seconds at the beginning of each filter cycle. The low speed of pump 1 runs during filtration and the ozone steriliser (if installed) will be enabled.